UNISAT Training Program Based on HEPTA-Sat. Hardware Communication Software UniSat AlfaSat Apr 05, 2021 Introduction Introduction to UniSat Training Program What is a CubeSat? Lab-0: Check parts and Boards Check specification of lowest components Item Lab-1: Programming of On-Board-Computer Required Software Installation Working with Linux OS Working with Cameras Lab-2: Electrical Power Supply Subsystem Check Function and architecture of EPS Inhibit Design Charge Control Function Power Supply Function Release Detection Switch Assembly and Integration, Test of EPS Voltage Converter Charge Management Controller Battery Temperature Regulation Lab-3: Communication and GPS Subsystem Check Function and Architecture of TRX Acknowledgement Signal Command and Telemetry Function LoRa interface function Modulation and Demodulation Communication Link Design Communication Protocol Assembly and Integration, Test of TRX Data Transmitting Data Receiving Communication with Ground Subsystem Sensor-Board (SB) Subsystem Check Function and Architecture of Sensorboard Programming with I2C interface Scanning for Available Devices on SB Assembly and Integration, Test of Sensorboard Meteo Sensor Light Sensor Gyrascope/ Magnitometer/ Acceleration Geiger counter Lab-4: TOP Board Check Function and architecture of Structure Subsystem Assembly and Integration, Test of Structure Subsystem Working with Antenna and Top Board mission Lab-5: Structure Subsystem Check Function and architecture of Structure Subsystem Assembly and Integration, Test of Structure Subsystem Launcher Requirements Structural Design Structural Design Using 3D-CAD Flight Switch Physical Interfaces Assembling and Integration Lab-6: Mission design, Integration and Test Mission Design Mission Example Requirements Verification and Validation Mission Review and Report PREVIOUSAzure, AWS, GCP, Vultr Region Based Speed Test.NEXTMDN Frontend 2 Please enable JavaScript to view the comments powered by Disqus.